Did you know that there is no drain cleaner on hand?No worries, you can make your own using iodized salt.It should be possible to cut through the toughest clogs with the help of the combination of abrasive salt and cleaning agents.Adding boiling water to your mix will push the mixture through the pipes.
Step 1: Put salt and vinegar in a container.
Put 1 cup of salt in a small bowl.Add 1 cup of water.The salt will absorb the vinegar.Continue stirring until the mixture is smooth.Add a 1/2 cup of lemon juice and mix thoroughly to give your paste some extra declogging-power thanks to the juice's acidity.If you leave the lemon juice out, add more vinegar to the mixture to make it easier to travel.
Step 2: The mixture should be put into the drain.
The drain's stopper needs to be removed first.The mixture should be poured down the drain.If you coat the entire drain, it will absorb the mixture.It's best to allow it to sit for 15 minutes.Allow the clog to soak for 30 minutes.If you can't remove the stopper, add more vinegar to the mixture to make it thinner.
Step 3: The drain should be cleaned with boiling water.
Water can be boiled in a kettle or pan.The water should be poured directly into the drain.It's a good idea to pour slowly to avoid splash-back.You can aim the water directly into the drain instead of splashing the basin if you pour slowly.It may take a while for the hot water to kick in, so use boiling water instead.
Step 4: Put the dry ingredients down the drain.
For mixing, use a narrow cup or glass.Baking soda should be put in a 1/2 cup.Add a small amount of salt.They should be evenly mixed.If there is one, remove the stopper from the drain.The contents should be poured down the drain.
Step 5: Add warm liquids.
Put 1 cup of vinegar in the microwave or on the stove.Pour it down the drain once it is simmering.The baking soda will cause the vinegar to froth and bubble if the drain is not covered immediately.For the best results, keep the reaction within the drain as small as possible.
Step 6: The drain needs to be cleaned with boiling water.
Wait 15 minutes so the mixture can be absorbed.Wait 30 minutes for tougher clogs.2 cups of water should be boiled.After the time has passed, remove the drain cover and pour the boiling water down it to rinse.
Step 7: salt down the drain
Since it is so coarse and abrasive, salt alone will cause the inside of the pipe to be scoured.A cup of salt is 1/2 cup.Put it down the drain.
Step 8: The drain needs to be washed with boiling water.
2 liters of water should be boiled.Slowly pour it down the drain.It's a good idea to aim the water directly into the drain.To flush the drain, run hot water from the tap after the water has been boiled.
Step 9: Go on.
Since you are only using salt, you will probably need to do this a few times.Continue to add salt until you get to a point where you need more.Don't dump too much in at one time.