How do I run a diagnostic on my Whirlpool washer?

How do I run a diagnostic on my Whirlpool washer?

https://www.youtube.com/watch?v=Q239fB24wxY

How do I reset my Whirlpool washing machine?

Method 1: Unplug it The first way you can reset whirlpool washer top load is by unplugging it for about 2 minutes then plug it back in and wait about 30 seconds before starting the washer again. This performs a hard reset on the machine and it will start over after you reconnect it again.

How do I reset the control panel on my Whirlpool washer?

Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset.

How do I know if my shift actuator is bad?

If the switch is defective it will think the lid is open and will not allow it to spin. if the drum is spinning but not at a high enough speed to spin the water from the clothes, I suggest testing the Shift Actuator,PartSelect Number: PS11747977.

Related Posts:

  1. The lawn mower won't move, you have to put the model 2 347 dixie chopper in neutral.
  2. Can you tell me how much it will cost to fix a washing machine?
  3. How to fix/and what's causing play store error df-dla 15 onSamsung...
  4. How do I wire a 3 way switch with red and black?