Your see a large switch or handle between the entry point and the electric meter. The switch or handle is in the off position. Move the switch, or turn the handle, to the on position. This turns on the electrical supply and your meter registers electrical usage.
How do I turn my electric back on with a smart meter SSE?
- The screen will show the message, “PRESS B FOR ELEC”.
- Press the B button.
- The screen will show the message, “EN SUPPLY? A=NO B=YES”.
- Press the B button.
- The screen will show the message, “SUPPLY ENABLED”.
How do I reconnect my electric meter?
Attach the home's wiring to the meter. Connect the red and black wires, one each, to the two bottom screws on the rear of the meter, and tighten the screws down on the wires. Slide the rear of the meter into the socket and tighten the screws down to lock it in place.
Why is my smart meter not connecting?
To restore the lost connection to your smart meter, you'll need to: Take your In-Home Display to where your electricity meter is located. Once you're close to the meter, hold down the “OK button” until the In-Home Display turns off and then on again. You should then see the message: “your smart meter is now paired”.
How do I reset my smart meter?
To reset it it turn it right off by holding down the power button for 10 seconds and then power it back on again, it should work.
How do I pair my smart meter?
It usually takes about three hours. Press and hold the power button on the back of your smart meter display to turn it on. To turn it off, press and hold the same button for five seconds. Each time you turn the smart meter display on, it will show 'Welcome to IHD2' then 'Attempting to pair'.
How do I turn my gas supply back on my smart meter?
https://www.youtube.com/watch?v=7GdWcyDbRvk
How do I turn my gas meter back on?
https://www.youtube.com/watch?v=VyEfXqMh74A
How do I reset my digital power meter?
To do so, press the RESET button on the front panel of the meter. If pressing the RESET button does not automatically set all of the readings back to zero, press and hold the ENTER button while simultaneously pressing the RESET button.
How do I reset my British Gas smart meter?
My smart energy monitor has gone blank Unplug your smart energy monitor. Move it closer to your electricity meter. Plug your smart energy monitor back in. Wait seven days (most smart energy monitors re-start automatically within a week)