The use and care manual for the appliance is in the PDF form.

Your Refrigerator has innovative storage and energy efficient features.

If you want to use the features and functions of your new appliance, you need to read the manual thoroughly.

Unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety, this appliance is not intended for use by people with reduced physical, sensory or mental capabilities.

The characteristics of your refrigerator may be different from what is described in the manual.Contact us if you have any questions.

Don't place the fridge in the sun or expose it to the heat from the stove or other appliance.

Plug several appliances into the same power board.The fridge should always be plugged into its own electrical board which has a rating that matches the plate.

This provides the best performance and also prevents overloading house wiring circuits, which could cause a fire hazard from overheated wires.

Pull the power cord on your refrigerator.Pull the plug out from the outlet.

Installation and location of the refrigerator must be in line with the manual.

If you connect the power plug upside down, the wire can be cut off and cause a fire or electric shock.

Before attempting to repair or investigate any part of the appliance, make sure that you grounded the Refrigerator.Severe electric shock can be caused by power leaks.

Gas pipes, telephone lines, and other potential lightning attractors should never be used as an electrical ground.

If it's necessary to use an extension cord, use a 3-wire one that has a grounding plug and a receptacle that accepts the plug on the appliance.The rating of the extension cord should be marked.

If the power cord is damaged, have it replaced by the manufacturer or its service agent.

The articles may fall and cause injury when you open or close the door.

Storage of benzene, thinner, alcohol, ether,LP gas and other products may cause explosions.

Do not store pharmaceuticals, scientific materials or temperature sensitive products in the fridge.

Unless the appliance is recommended by the manufacturer, don't put it inside the refrigerator.

Don't use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.

Air the room in which the appliance is standing for several minutes if a gas leak is detected.

Pull out the power plug if there is a burning smell or smoke.

Pull out the power plug from the fridge and contact the service center.

Don't put drinks in the freezer compartment.Do not put bottles in the freezer.

Any changes or modifications performed by a 3rd party on this finished appliance is not covered by the warranty service of the company.

The refrigerator can be over cooled if the air holes are blocked.The water filter may break if the cooling period lasts too long.

Wait at least five minutes before plugging the refrigerator back in if it's disconnected from the power supply.

If you are going to be away for a long period of time, you need to empty the refrigerator and remove the power plug.

Foods should not be placed too close to the vent at the rear of the appliance as this will block the free air circulation in the refrigerator compartment.

Wrap the food up and put it in the refrigerator.

Pull out the power plug when the refrigerator gets wet.

Dust and foreign matter can be found on the power plug pins.Do not use a wet or damp cloth to clean the power plug pins.

Children may not be able to climb inside if the shelves are left in place.Don't let the pipes on the back of the appliance get damaged before disposal.

The door/door seals and door latch should be removed when disposing of this refrigerator.

In the insulation, cyclopentane is used.A special disposal procedure is required for the gases in insulation material.Please contact the local authorities if you have any questions.

It is safe to dispose of this product.Don't let the pipes on the back of the refrigerator get damaged before disposal.

You have purchased a Side-by- Side Refrigerator.The new appliance has many state-of-the-art features that we hope you will enjoy.

The front leveling legs should be above the floor to prevent floor damage.Refer to the manual for Leveling the refrigerator.

Place a packing carton under the refrigerator to protect the finish of the flooring.

Pull the fridge straight out and push it back in.

First things first!Measure doorways, thresholds, ceilings, stairways, and other things to make it easy to move your refrigerator to its final location.

When installing, allow clearance to the right, left, back and top.This will help you save money on your energy bills.

Before removing the freezer door, make sure the water supply line is disconnected.Refer to the manual for "Separating the water line" to avoid damage.

You are ready to use the features and functions of the appliance after your new Refrigerator is installed.The Refrigerator should be fully operational by completing the following steps.

You can check the power supply and electricity source at the back of the user's guide.Contact your service center if you have more questions.

The Refrigerator should be placed between the wall and the fridge.Refer to the instructions in the manual.

When you open the doors, make sure the interior light comes on.

Wait for an hour and set the temperature to the lowest possible temperature.The motor will run smoothly and the freezer will get slightly chilled.

It will take a few hours to reach the right temperature after the Refrigerator is powered on.After the temperature is sufficiently cool, you can store food and drinks in the Refrigerator.