Where is the Control Lock unlock button on Whirlpool washer?
Where is the Control Lock unlock button on Whirlpool washer?
- Locate the "Control Lock/Unlock" button on your Duet's control panel. ...
- Press and hold the "Control Lock/Unlock" button for three seconds.
- Release the "Control Lock/Unlock" button when the control lock icon on the display disappears.
How do I turn off the lock on my Whirlpool washing machine?
Press the button for that dedicated key to activate and deactivate the Control Lock. To turn off Control Lock, press and hold the Options key that says "Control Lock Hold 3 Sec" under it for 3 seconds.Jun 15, 2020
How do I reset the control panel on my Whirlpool washer?
Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset.
Where is the reset button on a Whirlpool washer?
https://www.youtube.com/watch?v=8l_9OcQRcH8
How do you put a Whirlpool Duet washer in diagnostic mode?
https://www.youtube.com/watch?v=HnevK4kd9Tg
How do you reset a locked Whirlpool washer?
Unplug your Whirlpool washer and leave it unplugged for 45 minutes. After 45 minutes, plug your washer back in. The washer's programming should be reset and the door should open.
Why is my washer stuck on lock?
The most common cause is water left in the machine. Try running a spin/drain cycle. If this fails, the machine can be drained by placing the washing machine drain hose lower than the drum (into a bucket or tray). The door interlock has simply jammed.
How do you bypass the control lock on a Whirlpool Duet dryer?
- Locate the “End of Cycle Signal” button. This is located on the right side of the Duet model dryer.
- Push the button and hold it down for 3 seconds.
- The Control Lock LED should turn off letting you know that your dryer is no longer locked.
How do you unlock a dryer control?
Press and hold the Extended Tumble and - (minus) buttons for 3 seconds. The control lock icon will flash while locking/unlocking, stay on when locked, and turn off when unlocked. NOTE: The Power button can still be used when the machine is locked.